- Home
- STUCKE
- Eco gc
Eco GC
Auto Start Load Share unit
Multi genset load sharing (up to 32 gensets)
kW and kV Ar load sharing
Busbar voltages and frequency measurements
Dead bus sensing
Bus failure detection
Sequential set start
Manual voltage/frequency adjustment
Load dependent automatic Start/Stop
Equal aging of gensets
Direct/Reverse governor and AVR control
Volts,frequency and phase matching
Synchroscope display
Logic Controller functionality for PLC
Black or gray theme selection for 4.3″ TFT LCD screen
- Pre-Alarm Engine temperature
Oil pressure
Fuel level
Over / Under voltage
Over / Under frequency
Over / Under speed - Warning & Electrical trip
Earth fault
Over current
Short circuit - Alarm
Generator breaker not opened
Generator breaker not closed - Controls
Fuel and Stop solenoid
ECU power and stop
Starter motor
Automatic generator start
Preheat
External alarm horn
Engine cooling
Idle mode
- Fail Monitoring Emergency stop
Failed to start
Low oil pressure
High temperature
Speed failure
Voltage failure
Charging fail
Shutdown
Warning
- Error
Over / Under speed
Speed loss
Earth fault
Fuel level
Battery low
Battery high
Maintenance
Over current
Short circuit
Engine stop
CanBus
Charge alternator
Dimensions
Panel Cut-Out
Protection
Weight
Environmental Rating
Operating/Storage Temperature
Operating/Storage Humidity
DC Battery Supply Voltage
CT Secondary
Sender Measurement
Communication Interface
: 276 mm x 189 mm x 45 mm. (including connectors). Plastic housing for panel mounting.
: Panel Cut-Out : 223mm x 162mm.
: IP65 at front panel.
: Approximately 0,82 Kg.
: Standard, indoor at an altitude of less then 2000 meters with non-condensing humidity.
: -20°C to +70°C / -30°C to +80°C
: 95% max. (non-condensing)
: 8 to 32 V dc (Peak: 36Vdc) Max. operating current is 860 mA.
: 5A.
: 0 to 1300 ohm, accuracy: 1 % FS, resolution: 1 ohm.
: USB programming and communication port, CanBus
communication with 1939 ECU, CanOpen, Ethernet, RS485.